Janome 9200D serger review: Threading beehive type

There are many reasons why this Janome 9200D is in the best serger reviews and they are its feature that you may want. Don’t need to wait more, start now and find out the answer for the question: “Why is it placed in the list?”

Raise the presser foot and et the tension dial to zero. This allow the thread to be inserted easily between the tension discs when threading. Next slide the looper cover to the right and pull it open. Now open the cover. When threading your machine, you should always ensure that each thread slots into its guide on the thread guide bar from back to front. It is also important to insert each thread through its left on another thread guide placed from the top then back over the top and down through the right and hole from top to bottom.

Janome 9200D

Threading the lower looper

Lead the right hand thread towards you through the guide and under the tension disc. You should always make sure the thread is correctly inserted between the tension discs by holding both lint and tugging gently. Now pass the thread over the guide and through the next three guides marked green. Take the thread pass through from right to left and hook it into the lower looper thread guide. Turn the balance wheel towards you until the needles on the lowest position. Now … Turn the balance wheel towards you until the needles are in the highest position. Take the thread pass through the aisle of the looper and pull towards the back.

Threading the upper looper

Now, you lead the second thread towards you through the guide and under the tension disc check that it is inserted correctly and pass the thread over the guide and though the next two guides marked red. Turn the balance wheel towards you until the needles are in the lowest position. Insert the thread behind the white thread guide and pass it through the aisle of the upper looper from front to back .

Then, you close the cover and place the threads under the foot to the left.

Threading the needles

To thread the needles on your serger, you need to ensure that they are in the highest position. Pass the thread from the third spool pin under the tension disc and then under the the right needle thread guide and over the take-up lever thread guide from right to left. Hook the thread around the needle thread guide from left to right and then behind the needle bar thread guide. Now pass it through the aisle of the right hand needle from front to back and finally under the foot to thread the left hand needle. To thread the left hand needle, take the thread from the left hand spool pin and pass it under the tension disc and slide over the take-up lever thread guide from right to left . Hook the thread around the needle thread guide from right to left and then behind the needle bar thread guide. Now pass it to the eye of the left hand needle from front to back and finally under the foot.

This machine gives you a wide variety of overlocking features. It ensures three or four thread operation and owns a built-in rolled hem for a professional finish. The cutting width is about 2.0 to 5.7 mm. Besides, the 9200D equips standard ball point needles, presser foot lifter and an electronic foot control.

The Janome 9200 Serger offers a two years warranty. Each product includes all full details. More, this two year may even extended up to five years, which is available on almost models sold in UK. Each product encloses an application form and the customer can purchase an extended warranty online.

If you are looking for a serger for your sewing, this machine can satisfy you. It is really easy when you break off the old thread and pull the new one through. The pathways for each separate thread are color coded so it is not too tough to rethread if you want to. Sews well. Book easy to follow. Moreover, it is also a good machine for the price.

Leave a Reply

Your email address will not be published. Required fields are marked *


*